Zennio-MAXinBOX66V3 - 6outputs-6inputs-knx-actuator-ZIOMB66V3

Multifunction sensor-actuator for DIN-rail (4.5 units) with 6 outputs (16 A C-load) which offer multiple configurations as shutter channels or individual outputs. It allows manual control of its outputs through the push buttons on the cover. It includes 10 independent logical functions. In addition, it incorporates 6 analogdigital inputs that may be configured as binary inputs for sensors and potentialfree push buttons, as temperature probe inputs or as motion sensor inputs. Four room thermostats to control heating/cooling systems are included. It is compatible with KNX Secure. Accessories: temperature probe and motion sensor.

Characteristics:

• Mounting on DIN rail (EN 50022), pressurized.
• Does not require a power supply other than the bus power supply.
• Integrated BCU KNX bus coupling unit
• Equipped with 6 action channels configurable as:
  • shutter channels (up to 3)
  • individual outputs (up to 6)
• 6 analog/digital inputs.
• Independent manual control by output with push button and LED status indicator.
• Includes logic functions
• Delay on outputs
• Full data backup in case of power loss
• Withstands capacitive loads, maximum 140 µF.
• Complies with EC directives.

SAFETY INSTRUCTIONS

• Do not connect the main voltage (230V) or other external voltages to the KNX data bus.
• Connecting an external voltage can endanger the electrical safety of the entire KNX system.
• Use rigid cable to connect the outputs or flexible cable with terminals (spikes).
• Always check during installation that there is sufficient insulation between the 230V main voltage conductors and the conductors of the Bus and its extensions.
• It is possible to connect several phases, making sure that each phase is on a different terminal block (block 1, block 2, block 3 and block 4).
• Once the device has been installed, the output terminals must not be accessible.